Freepbx zaptel installation

This will completely re-format the hard drive you install it on. The links below are downloaded from our US Based Server.

For more in-depth guidance, the FreePBX wiki offers step-by-step installation instructions. Click here to see the installation wiki page. Note: If this is a brand new install, the latest FreePBX Distro at the top of the page will be, in most cases, the most efficient way to install a complete FreePBX system that is ready to configure for your needs.

Refer to the installation instructions above. Hardware requirements will differ depending on the number of users and concurrent calls required for your deployment. You can find details by visiting our Commercial Modules page. A list of all supported IP phones is located here. Skip to content. FreePBX Distro. The config editor is a decent simple alternate yes there are other options as well.

I admit I was looking for some feedback pointing me in the direction where I could enable the Config Edit module. But It sounds like there is no easy way of doing this. As you mentioned I am sure different users would like to see different features. I am going to think of another way of editing my files without having to ssh every time I need to.

Hi Gents, I have a perfectly working server as follows: Asterisk 1. Config Edit is not only Trixbox. Other distros are using it like PIAF. Please read my post before making irrelevant suggestions. Any one? Many thanks for your answer and response. Appreciate your help. To load zaptel modules when system boots, you need to do a few more steps. Thanks once again for your time. So what could you recommend I use??